![yamaha ecu flash yamaha ecu flash](https://www.vividracing.com/wm.php/images/ftecu-ecu-wiring-harness-plug.jpg)
YAMAHA ECU FLASH UPDATE
If it does then the plug is not clipped back together firmly enough.įOR USE WITH OUR ON BIKE FLASH-TUNE KITS PLEASE SEE UPDATE AT END OF THIS ARTICLE The Green cable should not come back out. Push the green cable into the now vacant hole for pin 27 until it will go no further and then clip the white clip back in place from the two white tabs side.
![yamaha ecu flash yamaha ecu flash](https://cdn3.volusion.com/wqlzo.dxbfw/v/vspfiles/photos/YX-ECURF-2.jpg)
You should then be able to remove the white waterproof cover on the Pin 27 (for R1 09-12) the second from the left at the bottom row in this picture.
YAMAHA ECU FLASH DRIVER
Use a small screw driver to push the single longer on in, (one side is a single longer white tab and the other is two smaller white tabs. Next I took the top (smaller) ECU plug and pressed in the white tab on the connector. Then I removed the ECU (4 clips – be careful) and took the (3) bolts out that hold the ECU holder in place. Next removed the left hand side dash trim (2 bolts) and the tray thing under it (2 bolts 1 quick fit screw clip), Mid Panel (that runs top to bottom, just take the (2) allen bolts out the top and pull it out the way) and the coolant bottle cover (2 Bolts) there is NO NEED to lift tank, or remove air tubes. So, first off removed left hand side front panel (5 Allen bolts on outside, 2 quick release clips and 1 quick fit screw on the inner fairing) and the seat (2 allen bolts) Two shift rods that connect to either end on the sensor (don’t assemble that yet though.)Īll in it took me less than an hour and only required M10, M8 Spanners, Allen keys for fairing, pointy nose pliers to get the white pin cover out, flat head screwdriver to open the connector, 8 cable ties and some snippers to cut the excess cable ties. The Quick Shifter sensor with long grey cableģ. Short cable with a white connector and at the other end a green cable and a brown cable the later with a round spade type connector.Ģ. In the Quick Shifter kit there are a few bits,ġ. So today thought it was time I fitted my ECU remap controlled Quick Shifter kit.